Filling of ceramic joints, terraces and floor tiles. Repair in swimming pools. Specially designed to fill and waterproof joints in floors and walls, ceramics with absorption capacity ≤ 3%, porcelain stoneware, vitreous mosaic, with natural stone platelets. Indicated to work in humid places like bathrooms, kitchens or swimming pools, in occasional or permanent contact with wate
Warning: Last items in stock!
FIELDS OF APPLICATION
APPLICATION AND PREPARATION OF THE SUPPORT
The surfaces to be joined must be clean, free of dust, grease and release agents, to ensure a good adhesion of the mortar
In a clean container, preferably made of rubber or plastic, add 0.2 to 0.3 liters of water per kg of product and mix until a homogeneous paste is obtained, without lumps. Let the dough rest 3 minutes before the application. Do not knead once the setting has begun. The mortar - glue must be set before applying the grout.
Apply with rubber spatula diagonally over the joint and press without rubbing. When the product begins to set, clean with a damp sponge and then clean the remains with a dry cloth. The ceramic coating gasket will be clean throughout the thickness of the coating.
Clean the tool with water, immediately after use.
Do not apply at temperatures below 5 ° C or above 35 ° C.
Do not apply on plaster or on floors with underfloor heating in service or external supports in full sun.
Do not apply on substrates subjected to deformations of diverse origin or intense traffic or on surfaces exposed to chemical aggressions or pressurized cleaning water
If the surface of the coating is not vitrified, carry out a test before the installation of the mortar washability or protect the surface with a wax to prevent the pigments of the mortar from penetrating the coating.
Tool: Smooth rubber trowel or spatula
Cleaning Tool: With water, immediately after using
Joint width: 0-10 mm
Rest time: 3 minutes
Working time: 1 hour at 20 º C
Performance: Depending on the size of the ceramic, width and depth of joint: 500 - 700 gr for formats of 20x20 cm, thickness 8 mm and joint of 5 mm, 1 Kg for formats of 40x4 0 cm, thickness 10 mm and gasket 1 0mm
Drying Time: variable according to thickness and climatic conditions