DESCRIPTION

Two-component epoxy enamel 100% solids with sanitary certificate, for the painting of drinking water tanks, wastewater and food products installations in general where a constant cleaning and disinfection is needed.

PROPERTIES

• Good adhesion on construction materials.
• High resistance to abrasion, scratching and impact
• Easy to wash, decontaminate and maintain.
• Total liquid tightness (Impermeability of the applied film).
• High thickness of application.
• High hardness and mechanical resistance.
• Health compliance certificate reference number 0821418388.
• It complies with VOC 2010 regulations for the construction sector.
  

APPLICATIONS

• Painting of drinking water and residual water tanks.
• Painted in general for the protection and repair of pavements, baseboards and ceilings in food facilities, laboratories, health centers, warehouses, etc.
• Use, especially in slaughterhouses, canneries, lactic industries, cold rooms, operating rooms, veterinary centers, etc.
• It is also suitable for painting pavements for heavy industry with heavy loads and friction.
• Not suitable for metallic or fiber deposits and for application at temperatures below or equal to 40 ºC.
  

Presentation

Colors: White
Appearance: Bright.
Packaging: 4 Kg (Comp.A: 2,969 / Comp.B: 1,031)
Health certificate reference number 0821418388 according to Royal Decree 866/2008, 103/2009 and 847/2011

TECHNICAL DATA

• Yield: 1.3 - 3.8 m² / Kg (Approximate per layer).
• Drying:
  
  • To the touch: approx 7h (at 100μm, 23ºC and 55% relative humidity)
  • Total: From 6 h (100μm, 23ºC and 55% relative humidity)

• Repainting: After 24 hours (100μm, 23ºC and 55% relative humidity).
• Total hardness at 7 days
  

Application instructions

• Temperature: 10 to 30ºC. The temperature of the substrate must be 2-3 ° C above the dew point to avoid condensation and the relative humidity must be less than 80%.
• Number of layers: Two.
• Recommended thickness: 100 microns per layer
• Tools: Roller, Brush, Trowel
• Dilution: Not accurate.
• Cleaning: Epoxy solvent (cleaning of working utensils only) Art. 7605000
• Mixing ratio: By weight: 2.88 (Comp A) / 1 (Comp B) Epoxy hardener Enamel glaze Art. 7176999. In volume: 2,2 (Comp A) / 1 (Comp B) Epoxy hardener Gloss glaze Art. 7176999.
• Life of the mixture: 1 hour at 20ºC
• Remarks: Shake conveniently before application
  

Surface treatment

The surfaces, in general, must be dry, firm, clean and free of grease, dust and rust. Eliminate the elements that present bad adhesion.

• New surfaces: Proceed to remove the surface layer of cement (grout). To ensure a good adhesion, this layer must be removed with steel brush, acid cleaning or, in some cases, by milling or blasting the surface, proceed in the same way in case of polished concrete to open the pore. Then proceed to the direct application of the product in one or two coats depending on the required thickness
• Old surfaces: In case of badly adhered paints, eliminate by milling or blasting and proceed as a new surface. In the case of well-adhered epoxy systems, thoroughly clean the stains of grease, oil and dirt, tint the surface by sanding and proceed with the application of two coats.
• Application: The two components will be mixed preferably with a mechanical stirrer. The useful time for the mixture decreases the greater the amount mixed and the higher the ambient temperature. The application is made by spreading over the entire surface and preventing air from remaining occluded, which could later form pores.